Features
 
 
     
 
Salient Features for Sami Automatic
Click on Picture to Enlarge View Click on Picture to Enlarge View
Click Here for Enlage Image
Semi Automatic Round
Innerkay water Heater with auto Ignition System
Prise : - $ 23°°
Click Here for Enlage Image
Semi Automatic Rectangular
Also Available in Storage Storage Water Heaters with flam failer device and fully automatic operation.
Prise :- $ 279°° for 75 Ltrs.
           $ 319°° for 140 Ltrs.
Safe:
 
No Risk of Electric Shocks.  
As Safe as Gas Stove  
Auto Ignition System  
Covered Burners & Flames  
Lots of Units are in Service (In Winter)  
   
     
Convenient:
 
 
Any Type of Water Can Be Used  
Hot Running Water Starts within 10 Seconds  
15 Liters at 55 Deg. C water in just 5 Minutes (in Water)  
Hot water Temperature Control through water inlet  
Low Maintenance - 1 year free Service by manufacturer  
Wall Mounted -Easy installation -Portable  
Compact Design & Good Aesthetics  
Available in Stainless Steel & Powder Coated Colors OnSS. (On Request)  
   
 
Economical:
 
Most Economical & Fuel Efficient Equipment For water Heating  
1 Bucket of 15 Lts. At 55 Deg. C Water Coast Only 20 Paise  
70% Savings Compared to Electricity  
40% Savings Compared to Normal gas Stove ( For Water Heating)  
1 gas Cylinder Gives output of Approx 500 Buckets of 15 Lts At 55 Deg.c  
Payback period For Family of four 20-24 months.  
   
   
General information:
 
Do not Use Without Water  
Hot Water outlet Should Not be kept Open Permanently  
Instant Heater Should Not be Connected To Shower Etc.  
Proper Ventilation & Min.18 Inches Distance Required From Celling.  
   
 
Erection & Commissioning:
 
Fix the equipment with four screws with help of wall mounting brackets.  
ENSURE PROPER VENTILATION * MIN 18 INCHES DISTANCE IS AVAILABLE FROM THE CEILING .  
Connect water inlet & gas inlet separately .ENSURE THERE IS NO LEAKAGE FOR BOTH. Check the water outlet though controlling eater inlet.  
   
   
Operating Instruction:
 
Start cold running water and check water outlet .  
Turn the gas knob to on position (anticlockwise) & the spark will ignite the burners.  
In case it does not ignite in the beginning , IMMEDIATELY TURN THE KNOB TO OFF & REPEAT THE SAME . DO NOT KEEP KNOB ON. AFTER PRACTICE OF 5 TO 10 TIMES YOU WILL BE USED TO GAS & SPARK SYNCHRONIZATION SYSTEM.  
Adjust the outlet water temperature through water inlet control .  
After finishing your work turn the gas knob to OFF position & wait till cold water comes out from outlet, then only stop the water inlet.DO NOT ALLOW HOT WATER REMAIN INSIDE THE GEYSER  
SWITCH OFF THE REGULATOR OF CYLINDER WHEN IT IS NOT IN USE.  
   
   
DO NOT TOUCH THE TOP PORTION OF THE GEYSER IN WORKING CONDITION AS IT REMAINS HOT.
 
The Site Copyrighted By Innerkay Gas Geyser. All Rights Reserved By DEEP TECHNOLOGIES